Model：JH-CBP001
PP or polypropylene anti-corrosion centrifugal blower, with a bending strength of not less than 196Mpa, smooth surface of each section, no defects such as cracks, gaps, burrs, etc., with good overall effect. When conducting static balance test on the fan, the rigid rotor is rated G6.3 according to the “balance accuracy”, with a gap of 30mm from the cylinder wall and a tip error of not more than 10mm. The fan has reasonable aerodynamics, large volume, low noise, high efficiency, and corrosion resistance.
1. Appearance: Rice grey polypropylene PP board has the characteristics of anti-ultraviolet, anti-aging, anti-acid, strong alkali, corrosion resistance, etc.
2. Motor rain cover: simple structure, easy to use, prevent the motor from being wet by rain, extend the life of the motor.
3. Working principle: The working principle of centrifugal fan is basically the same as that of turbine compressor. Both are due to small gas flow rates and small pressure changes.
4. Application locations of PP centrifugal blower: It can be widely used in chemical industry, laboratory, ventilation equipment, metallurgy, electroplating, textile, instrumentation, scientific research units to pump toxic or corrosive gases in the range of -8 degrees +80 degrees.
| No | Model | Power | Rotational speed | Flow rate | Total pressure | Inlet size | Outlet size |
| 1 | 4A | 1.5KW | 1450 | 2856-5281 | 634-416 | Φ400 | 300*310 |
| 2 | 5A | 2.2KW | 1450 | 3864-7728 | 790-502 | Φ500 | 355*390 |
| 3 | 6A | 4 KW | 1450 | 6677-13353 | 1139-724 | Φ600 | 470*420 |
| 4 | 7A | 5.5KW | 1450 | 6800-14530 | 1150-748 | Φ600 | 470*420 |
| 5 | 8A | 7.5KW | 1450 | 10602-21204 | 1550-984 | Φ700 | 550*490 |
